Updates to Admin Policy Tool and Wyse Management Suite policy settings
Disabling Push Notification—Ignore MQTT in
Services > WDA Settings is changed to
Disabling Push Notification.
VNCD Server—Added input validation for the VNCD Server field in
Services > VNC Service. You can only enter values in the format of IP addresses.
Disable Shutdown—Added
Disable Shutdown option in
Login Experience > Login Settings. This option disables the
Shutdown option in the ThinOS
Shutdown window, and also disables the physical shutdown button on the thin client.
Login Expire Time—Added
Login Expire Time option in
Login Experience > Login Settings. Using this option, you can set a countdown after you log in. After the countdown expires, to launch any new desktop or application, you must enter the user password. After you enter the password, the countdown starts again. Desktop or applications that you launch before the expiry of the countdown remains open and are not affected. To disable the countdown, set the value to
0.
NOTE:Configuration of this setting is not supported in this release.
Reboot on monitor connection—Changed the default value of
Reboot on monitor connection option under
Enable ProveID Embedded Mode in
Login Experience > 3rd Party Authentication > Imprivata to disabled.
API Key—Changed the
API Key field option in
Login Experience > Login Settings > Identity Automation > Identity Automation to password type to hide the input values.
Enable IPv6—Added the option
Enable IPv6 in
Network Configuration > Common Settings to enable or disable IPv6.
Scheduled Reboot and
Shutdown Settings—Added time format validation for the following fields under
System Settings > Scheduled Reboot Settings and
Scheduled Shutdown Settings:
Scheduled Reboot Settings > Scheduled Reboot Time
Scheduled Reboot Settings > Reboot after Idle Time
Scheduled Shutdown Settings > Scheduled Shutdown Time
Scheduled Shutdown Settings > Shutdown after Idle Time
NOTE:If you change the time zone on the local client, the
Scheduled Reboot settings and
Scheduled Shutdown settings takes effect only after a reboot.
Granular Control of Peripherals—Added
Granular Control of Peripherals in
Privacy & Security > Account Privileges to make the selected tabs visible in the
Peripherals window. To see this option, you must set the privilege level as
Customize and enable
Peripherals.
DHCP—Updated the
DHCP option in
Privacy & Security > Account Privileges. The setting is enabled by default. To see this option, you must set the privilege level as
Customize and enable
Network Setup.
Allow High Efficiency Video Decoding—Added
Allow High Efficiency Video Decoding option in
Session Settings > Blast Session Settings.
NOTE:OptiPlex 3000 Thin Client does not support this feature.
On Desktop—Moved
On Desktop option from
Session Settings > Citrix Session Settings to
Session Settings > Global Session Settings.
Business Hour Settings—Added
Business Hour Settings under
Services > WDA Settings. Administrators can now enable or disable session reporting and enable configure devices to do session reporting outside of business hours. Administrators can also enable configure devices to apply configurations outside of business hours.
NOTE:Configuration of this setting is not supported in this release.
For more information about the updates, see the
Dell Wyse ThinOS 9.1.4097, 9.1.4234, and later versions Administrator's Guide at
www.dell.com/support.
Les données de cette rubrique ne sont pas disponibles
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez indiquer si l’article a été utile ou non.
Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\