Passer au contenu principal

Dell PowerVault ME4 Series Storage System CLI Guide

PDF

show enclosures


Description	Shows information about the enclosures in the storage system. Full detail available in API output only. If a connected expansion enclosure is not supported, it will not be listed and events 315 and 443 will be logged.
Minimum role	monitor
Syntax	show enclosures
Parameters	Encl The enclosure ID. Encl WWN The enclosure WWN. Name The enclosure name. Location The enclosure location, or blank if not set. Rack The number of the rack that contains the enclosure. Pos The position of the enclosure in the rack Vendor The enclosure vendor. Model The enclosure model. EMP `controller-ID` BUS:ID Rev The channel ID and firmware revision of the Enclosure Management Processor in each controller’s Expander Controller. Midplane Type An abbreviation that describes the enclosure midplane's rack-unit height, maximum number of disks, maximum data rate to disks (Gbit/s), and hardware version. Health Show information about all enclosures in the system. # show enclosures OK Degraded Fault N/A Unknown Reason If Health is not OK, this field shows the reason for the health state. Action If Health is not OK, this field shows recommended actions to take to resolve the health issue. Drawer Information Drawer The number of the drawer. Name The name of the drawer. Status Status of the drawer Up Warning Error Unknown Unavailable Not Present Health OK Degraded Fault N/A Unknown Reason If Health is not OK, this field shows the reason for the health state. Action If Health is not OK, this field shows recommended actions to take to resolve the health issue.
Examples	Show information about all enclosures in the system. # show enclosures
Basetypes	enclosures status
See also	set enclosure show sensor-status