- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
Bienvenue
Bienvenue dans l’univers Dell
Mon compte
- Passer des commandes rapidement et facilement
- Afficher les commandes et suivre l’état de votre expédition
- Profitez de récompenses et de remises réservées aux membres
- Créez et accédez à une liste de vos produits
- Gérer vos sites, vos produits et vos contacts au niveau des produits Dell EMC à l’aide de la rubrique Gestion des informations de l’entreprise.
Inspiron 7405 2n1 Service Manual
Installing the M.2 2280 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
This computer supports two solid-state drive form factors.
- M.2 2230
- M.2 2280
If you are replacing the M.2 2280 solid-state drive with an M.2 2330 solid-state drive, the following images indicate where to install the solid-state drive bracket based on form factor.
The following image indicates the location of the M.2 2280 solid-state drive and provides a visual representation of the installation procedure.
NOTE Perform step 1 to step 3 if you are replacing the M.2 2230 solid-state drive with an M.2 2280 solid-state drive.
Steps
- Remove the screw (M1.6x2.5) that secures the solid-state drive bracket to the palm-rest and keyboard assembly.
- Turn the solid-state drive bracket at an angle of 180 degrees.
- Insert the solid-state drive bracket into the other solid-state drive bracket slot on the palm-rest and keyboard assembly.
- Replace the screw (M1.6x2.5) that secures the solid-state drive bracket to the palm-rest and keyboard assembly.
- Align the notch on the solid-state drive with the tab on the solid-state drive slot.
- Slide the solid-state drive firmly into the solid-state drive slot at an angle.
- Replace the screw (M2x3) that secures the solid-state drive to the solid-state drive bracket.
- Align the screw hole on the solid-state drive thermal bracket with the screw hole on the palm-rest and keyboard assembly.
- Replace the screw (M2x3) that secures the solid-state drive thermal bracket to the palm-rest and keyboard assembly.
Next steps
- Install the base cover.
- Follow the procedure in After working inside your computer.
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez indiquer si l’article a été utile ou non.
Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\