Passer au contenu principal
  • Passer des commandes rapidement et facilement
  • Afficher les commandes et suivre l’état de votre expédition
  • Profitez de récompenses et de remises réservées aux membres
  • Créez et accédez à une liste de vos produits
  • Gérer vos sites, vos produits et vos contacts au niveau des produits Dell EMC à l’aide de la rubrique Gestion des informations de l’entreprise.

Inspiron 7405 2n1 Service Manual

Installing the I/O board

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the I/O board and provides a visual representation of the installation procedure.

Image: Installing the I/O board

Steps

  1. Slide the I/O board into the slots on the palm-rest and keyboard assembly.
  2. Align the screw hole on the I/O board with the screw hole on the palm-rest and keyboard assembly.
  3. Replace the screw (M2x3) that secures the I/O board to the palm-rest and keyboard assembly.
  4. Connect the I/O-board cable to the connector on the I/O board and close the latch to secure the cable.
  5. Adhere the tape that secures the I/O-board cable to the I/O board.
  6. Connect the fingerprint reader-cable to the connector on the I/O board and close the latch to secure the cable.
  7. Connect the coin-cell battery cable to the I/O board.
  8. Close the left display hinge.
  9. Replace the two screws (M2.5x5) that secure the left-display hinge to the palm-rest and keyboard assembly.

Next steps

  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.

Évaluez ce contenu

Précis
Utile
Facile à comprendre
Avez-vous trouvé cet article utile ?
0/3000 characters
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez indiquer si l’article a été utile ou non.
  Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\