- Notes, cautions, and warnings
- Working on your computer
- Removing and installing components
- Recommended tools
- Subscriber Identity Module(SIM) board
- Base cover
- Battery
- Solid State Drive — optional
- Hard drive
- Coin cell battery
- WLAN card
- WWAN card
- Memory module
- Keyboard
- Heat sink
- System fan
- Power connector port
- Chassis frame
- System board
- Touchpad panel
- SmartCard module
- LED board
- Speaker
- Hinge cap
- Display assembly
- Display bezel
- Display hinges
- Display panel
- eDP cable
- Camera
- Display back cover assembly
- Palm rest
- Technology and components
- System setup options
- BIOS overview
- Entering BIOS setup program
- Boot Sequence
- Navigation keys
- One time boot menu
- System Setup overview
- Accessing System Setup
- General screen options
- System Configuration screen options
- Video screen options
- Security screen options
- Secure Boot screen options
- Intel Software Guard Extensions
- Performance screen options
- Power Management screen options
- POST Behavior screen options
- Virtualization support screen options
- Wireless screen options
- Maintenance screen options
- System Log screen options
- Updating the BIOS
- System and setup password
- Clearing BIOS (System Setup) and System passwords
- Technical specifications
- System specifications
- Processor specifications
- Memory specifications
- Storage specifications
- Audio specifications
- Video specifications
- Camera specifications
- Communication specifications
- Port and connector specifications
- Contactless smart card specifications
- Display specifications
- Keyboard specifications
- Touchpad specifications
- Battery specifications
- AC Adapter specifications
- Physical specifications
- Environmental specifications
- Diagnostics
- Enhanced Pre-Boot System Assessment ePSA diagnostics
- Device status lights
- Battery status lights
- Troubleshooting
- Drain residual flea power (perform hard reset)
- Contacting Dell
Dell Latitude 5580 Owner's Manual
Installing the battery
NOTE the 92Whr battery requires the use of a M.2 card and a 68Whr battery can be used with either a M.2 or 7mm SATA drive.
- Insert the battery into the slot on the computer .
- Connect the battery cable to the connector on the system board.
- Tighten the M2.5x5 screw to secure the battery to the computer.
- Install the base cover.
- Follow the procedure in After working inside your computer.
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez indiquer si l’article a été utile ou non.
Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\