Removing the display assembly
About this task
The figure indicates the location of the display assembly and provides a visual representation of the removal procedure.
Steps
- Remove the two (M2x3) screws that secure the EDP metal bracket to the computer.
- Peel the tape that secures the display cable to the system board.
- Open the latch and disconnect the display cable from the system board.
- Disconnect the touchscreen cable from the connector on the system board.
- Unroute the WLAN and WWAN cables from the retention clips.
- Remove the four (M2.5x5) screws that secure the display hinges to the chassis of your computer.
- Open the display hinges at an angle of 90 degrees and slightly open the display.
- Remove the palm-rest and keyboard assembly off the display assembly.
Aucune donnée n’est disponible sur le sujet