Passer au contenu principal
  • Passer des commandes rapidement et facilement
  • Voir les commandes et de suivre l'état de votre expédition
  • Profitez membres seulement récompenses et des remises
  • Créez et accédez à une liste de vos produits
  • Gérez vos sites Dell EMC, vos produits et vos personnes-ressources pour les produits dans Administration de l’entreprise.

Latitude 5401 Service Manual

Installing the display assembly

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The figure indicates the location of the component and provides a visual representation of the installation procedure.

Installing the display assembly

Installing the display assembly

Installing the display assembly

Installing the display assembly

Steps

  1. Place the display assembly on a clean and flat surface.
  2. Align and place the palmrest on the display assembly.
  3. Using the alignment posts, close the display hinges.
  4. Connect the display cable to the system board and adhere the tape to secure the display cable.
  5. Place the display cable metal bracket on the display cable connector.
  6. Replace the two (M2x3) screw to secure the display cable metal bracket to the system board.
  7. Connect the touchscreen cable to the connector on the system board.
  8. Replace the four (M2.5x5) screws that secure the display hinge to the chassis of the computer.
  9. Route the WWAN cable and the WLAN cable through the retention clips provided.

Next steps

  1. Install the WLAN card.
  2. Install the WWAN card.
  3. Install the battery.
  4. Install the base cover.
  5. Follow the procedure in After working inside your computer.

  Veuillez évaluer cet article (1 à 5 étoiles).
  Veuillez évaluer cet article (1 à 5 étoiles).
  Veuillez évaluer cet article (1 à 5 étoiles).
  Avez-vous trouvé cet article utile?
  Les commentaires ne peuvent pas contenir ces caractères spéciaux : <>()\