Installing the system board
Steps
- Align and place the system board on the palmrest [1].
- Replace the
two (M2x3) screws to secure the system board to the palmrest [2].
- Connect the cable to the connector on the system board [1].
- Connect the eDP cable to the connector on the system board
[2].
- Place the eDP support bracket above the eDP connector
[3].
- Replace the two (M2x3) screws to secure the eDP bracket to the system board
[4].
- Adhere the adhesive tape on the eDP cable that is connected to the system board [5].
- Connect the fingerprint cable to the connector on the system board [1].
- Place the fingerprint support bracket [2].
- Replace the single (M2x3) screw to secure the fingerprint support bracket to the system board [3].
- Connect the following cables to the system board:
- Speaker cable [1].
- LED board cable [2].
- USH FFC [3]
- Touchpad FFC [4].
Aucune donnée n’est disponible sur le sujet