Removing the system board
Steps
- Lift the latch and disconnect the following cables from the system board:
- Speaker cable [1].
- LED board cable
[2].
- USH FFC
[3].
- Touchpad FFC
[4].
- Remove the single (M2x3) screw that secures the fingerprint support bracket to the system board [1].
- Lift the fingerprint support bracket away from the computer [2].
- Disconnect the fingerprint port [3].
- Peel the adhesive tape on the eDP cable that is connected to the system board [1].
- Remove the two (M2x3) screws that secure the eDP bracket to the system board
[2].
- Remove the eDP bracket away from the computer
[3].
- Lift the eDP cable from the connector on the system board
[4].
- Disconnect the cable from the connector on the system board [5].
- Remove the
two (M2x3) screws that secure the system board to the palmrest [1].
- Lift the system board away from the computer [2].
Aucune donnée n’est disponible sur le sujet