NOTE:Ensure that the hinges are opened to the maximum before replacing the display assembly on the palmrest.
Steps
Align and place the system chassis under the hinges of the display assembly [1].
Replace the
four(M2.5x5) screws that secure the display assembly to the system chassis [2].
Seat the system chassis on the display assembly.
NOTE:Make sure to watch the cable positioning during LCD installation and also when closing the LCD to prevent pinching of the cables between LCD assembly and chassis.
Reroute the wireless antenna through the routing guides on the system board [1].
Connect the cable to the connector on the system board [2].
Connect the eDP cable to the eDP connector on the system board
[3].
Place the eDP cable bracket on the system board
[4].
Replace the two (M2x3) screws that secure the eDP cable bracket to the system board
[5].
Adhere the tape securing the eDP cable bracket on the system board [6].