Removing the display assembly
Steps
- Unroute the wireless antenna from the routing guides on the system board [1].
- Peel off the tape securing the eDP cable bracket [2].
- Remove the two (M2x3) screws that secures the eDP cable bracket to the system board [3].
- Lift the eDP cable bracket from the system board [4].
- Disconnect and unroute the eDP cable [5, 6].
- Open the display assembly to a 180-degree angle and flip over the system, then place the system on a flat surface.
- Remove the four(M2.5x5) screws that secures the display assembly to the system chassis [1].
- Remove the display assembly from the system [2].
Aucune donnée n’est disponible sur le sujet