If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the system board and provides a visual representation of the installation procedure.
Steps
Locate the system board slot on your computer.
Slide the ports on the system board into the slots on the palm-rest and keyboard assembly and align the screw holes on the system board with the screw holes on the palm-rest and keyboard assembly.
Install the two (M2x2) screws that secure the system board to the palmrest and keyboard assembly.
Replace the two (M2x5) screw to secure the type-C metal bracket to the computer.
Connect the coin-cell cable to the latch.
Connect the I/O board cable, keyboard transfer cable, and touchpad cable to the latch.
Route the cable, install the wireless cable, and connect the system fan cable to the connector on the system board.
Affix back the adhesive tape and connect the touchscreen cable to the latch. Replace the ED cable and connect the display cable to the latch on the system board.
Affix back the adhesive tape and connect the world-facing camera cable to the latch.
Replace the three (M2.5x5) screws to fix the hinge.
Replace the single (M2x3) screw to fix the metal bracket.