Installing the display assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the component and provides a visual representation of the installation procedure.
Steps
- Place the display assembly on a clean and flat surface.
- Align and place the palmrest and keyboard assembly on the display assembly.
- Using the alignment posts, close the display hinges.
- Connect the display cable to the system board and adhere the tape to secure the display cable.
- Place the EDP metal bracket on the display cable connector.
- Install the six (M2.5x5) screws that secure the display hinges to the chassis of your computer.
Aucune donnée n’est disponible sur le sujet