Dell PowerEdge R430 Owner's Manual

Replacing the system battery

Locate the battery socket. For more information, see the System board connectors section.
CAUTION To avoid damage to the battery connector, you must firmly support the connector while installing or removing a battery.
Place your finger between the securing tabs at the negative side of the battery connector, and lift the battery out of the socket.
Figure 1. Removing the system battery
1. system battery
2. system battery slot
To install a new system battery, hold the battery with the "+" facing up and slide it under the securing tabs.
Press the battery into the connector until it snaps into place.
Figure 2. Installing the system battery
1. system battery
2. system battery slot

Install the cooling shroud.
If removed, install the expansion card riser.
While booting, press F2 to enter System Setup and ensure the battery is operating properly.
Enter the correct time and date in the System Setup Time and Date fields.
Exit System Setup.