Ir al contenido principal
  • Realice pedidos rápida y fácilmente.
  • Vea los pedidos y haga el seguimiento del estado del envío.
  • Cree una lista de sus productos y acceda a ella
  • Gestione sus sitios, productos y contactos a nivel de producto de Dell EMC con la administración de empresa.

Dell PowerEdge R430 Owner's Manual

Installing a cabled power supply unit

Prerequisites

CAUTION Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
NOTE A hot-swappable non-redundant power supply unit (PSU) must be installed in Slot 1 of the PSU slot.

Steps

  1. Slide the PSU into the PSU slot.
  2. Align the screw hole on the PSU with the standoff on the chassis.
  3. Tighten the screw to secure the PSU to the chassis.
  4. Connect all the power cables to the system board, hard drives, and optical drive.
    Figure 1. Installing a cabled PSU
    This figure shows installing a cabled PSU.
    1. PSU
    2. screw
    3. P1 cable connector
    4. P2 cable connector
    5. P3 cable connector
    6. standoff
    7. backplane connector

Next steps

  1. Follow the procedure listed in the After working inside your system section.

Valore este contenido

Acertado
Útil
Fácil de entender
¿Le ha resultado útil este artículo?
0/3000 characters
  Proporcione valoraciones (1-5 estrellas).
  Proporcione valoraciones (1-5 estrellas).
  Proporcione valoraciones (1-5 estrellas).
  Seleccione si el artículo le ha resultado útil o no.
  Los comentarios no pueden contener caracteres especiales: <>()\