Dell PowerEdge M1000e Enclosure Owner's Manual

Configuring The Analog Switch

Press <Prnt Scrn> to launch the iKVM Switch OSCAR.
Click Setup > Devices > Device Modify .
Select the 16-port option to match the number of blades in your system.
Click OK to exit OSCAR.
Press <Prnt Scrn> to verify that the settings have taken effect. The slot number of the blade to which the iKVM switch is now attached must be expanded to display each of the slot locations of the blades in the system. For instance, if the iKVM switch is attached to slot 1, it must be displayed as 01-01 to 01-16.
Connect the Avocent iKVM switch to a supported analog switch: If the switch does not require a SIP to connect to the iKVM, connect a Cat 5 (or newer) cable to the RJ-45 ACI port on the iKVM module. Connect the other end of this cable to the ARI port on the external switch.
If the analog switch requires a USB SIP, connect an Avocent USB SIP to the iKVM, then connect a Cat 5 (or newer) cable to the SIP. Connect the other end of this cable to the ARI port on the external switch.
Connect both the analog switch and the system to an appropriate power source.
Turn on the system.
Turn on the external analog switch.

NOTE: If the external analog switch is powered up before the system, it may result in only one blade being displayed in the analog switch OSCAR, instead of 16. If this behavior occurs, shut down and restart the switch so that the entire complement of blades is recognized.

NOTE: In addition to the steps outlined above, some external analog switches may require you to perform additional steps to ensure that the iKVM switch blades are displayed in the external analog switch OSCAR. For more information, see the external analog switch documentation.