Dell PowerEdge M1000e Enclosure Owner's Manual

Configuring iDRAC Networking Using The Web-Based Interface

Follow this procedure to configure the iDRAC in the LCD configuration wizard.

NOTE: If you did not configure the iDRAC using the LCD configuration wizard, iDRAC is disabled until you configure it using the web-based interface.

NOTE: You must have Chassis Configuration Administrator privileges to set up iDRAC network settings from the CMC.

Log in to the web-based interface.
Click the plus (+) symbol next to Chassis in the left column, then click Servers.
Click Setup > Deploy .
Select the protocol for the iDRAC setting (IPv4 and/or IPv6).
Under Enable Lan, select the check box next to the server to enable LAN for iDRAC.
Under Enable IPMI over LAN, select or clear the check box next to the server to enable or disable IPMI over LAN.
Under DHCP Enabled, select or clear the check box next to the server to enable or disable DHCP for iDRAC.
If DHCP is disabled, enter the static IP address, netmask, and default gateway for the iDRAC.
Click Apply at the bottom of the page.