Near Field Communication
using the QuickSync feature
Using the QuickSync feature, you can:
View basic server information such
as Service Tag, MAC address, NIC data, firmware versions, operating
system, and so on.
View log and monitoring information
of a server.
Configure network parameters of a
server.
After viewing or editing the information, you can
troubleshoot or configure using a mobile device. To use this feature,
you must install the OpenManage Mobile (OMM) software application
on your mobile device and enable the bezel on the server. The QuickSync
feature enables your mobile device to act as a proximity reader which
reads data on the server when held at a distance of less than 20 mm
from the server front panel. You can perform most of the tasks that
you complete by using an LCD panel. The system information is the
basic hardware inventory information retrieved from NFC. The attributes
allow you to set the access, check the presence of QuickSync feature,
enable or disable the Inactivity Timer, set the inactivity timeout
value.
NOTE: This feature
is supported only on Android mobile devices.