Table shown here contains the supported options
used for RDP connections after you use the Connect=RDP parameter/selection.
NOTE:
If an option has an underlined value (default), that
option and default value will automatically be used with Connect=RDP;
options without underlined values can also be used if you want to,
but are not automatically used with Connect=RDP. In addition, when
using options, you can leave the default value or change it to another
value shown.
For example, in the following case
where:
Connect=RDP
[Option1={0, 1}]
[Option2={1, 2, 3, 4}]
Since you are using Connect=RDP, then Option 1 and
its default value 0 will automatically be used as Option1 has an underlined
value (default of 0). You can still use Option 2 if you want to, however,
Option 2 is not automatically used with the parameter as Option 2
does not have a default (underlined) value.
NOTE:
Any option in RDP Connect Options that is used in a {username}.ini file will return to the default
value set for that option in the wnos.ini file after a user sign-off.
For example, if your {username}.ini
file contains the option Reconnect=yes (so that a lost connection
will restart 20 seconds after disconnection) and you sign off of the
thin client, then the Reconnect value will return to the original
default value of no (Reconnect=no) contained in the wnos.ini file—so
that others who sign in can use their own user profile assuming the
administrator has not changed the default values in the wnos.ini file.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\