Table shown here contains the supported options used
for ICA connections (after you use the Connect=ICA parameter/selection).
NOTE:
If an option has an underlined value (default), that
option and default value will automatically be used with Connect=ICA;
options without underlined values can also be used if you want to,
but are not automatically used with Connect=ICA. In addition, when
using options, you can leave the default value or change it to another
value shown.
For example, in the following case
where:
Connect=ICA
[Option1={0,
1}]
[Option2={1, 2, 3, 4}]
Since
you are using Connect=ICA, then Option 1 and its default value 0 will
automatically be used as Option 1 has an underlined value (default
of 0). You can still use Option 2 if you want to, however, Option
2 is not automatically used with the parameter as Option 2 does not
have a default value.
NOTE:
Any option in ICA Connect Options that is used in a {username}.ini file will return to the default
value set for that option in the wnos.ini file after a user sign-off.
For example, if your {username}.ini file contains the option Reconnect=yes
so that a lost connection will restart 20 seconds after disconnection;
and you sign off the thin client, then the Reconnect value will return
to the original default value of no (Reconnect=no) contained in the
wnos.ini file—so that others who sign in can use their own user profile;
assuming the administrator has not changed the default values in the
wnos.ini.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\