Always follow electrical safety precautions
to avoid injury and damage to
Storage Center equipment.
WARNING: Disconnect power from the
storage
controllers
when removing or installing components that are not hot-swappable.
When disconnecting power, first power down the
storage
controllers
using the
Dell Storage Manager Client
and then unplug
the power cords from all the power supplies in the
storage
controllers
.
Provide a suitable power source with electrical overload
protection. All
Storage Center components
must be grounded before applying power. Make sure that there is a
safe electrical earth connection to power supply cords. Check the
grounding before applying power.
The plugs on the power supply cords are used as the
main disconnect device. Make sure that the socket outlets are located
near the equipment and are easily accessible.
Know the locations of the equipment power switches
and the room's emergency power-off switch, disconnection switch, or
electrical outlet.
Do not work alone when working with high-voltage
components.
Unplug the chassis before you move it or if you think
it has become damaged in any way. When powered by multiple AC sources,
disconnect all supply power for complete isolation.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\