- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of XPS 8940
- Left-side cover
- Optical drive (optional)
- Power button
- Front cover
- 2.5-inch hard drive
- 3.5-inch hard drive
- Chassis fan
- Memory modules
- Wireless card
- Solid-state drive/Intel Optane
- Graphics card
- Coin-cell battery
- Power-supply unit
- Processor fan and heat-sink assembly
- Processor
- Voltage regulator heat sink (optional)
- System board
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
XPS 8940 Service Manual
Installing the front cover
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the front cover and provide a visual representation of the installation procedure.
Steps
- Place the computer in an upright position.
- Insert the right-side front-cover tabs into the corresponding slots on the chassis.
- Push the left-side of the front cover towards the chassis, snapping the slots into position.
Next steps
- Install the left-side cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\