Installing the power button with fingerprint reader
CAUTION:The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the power button with fingerprint reader and provide a visual representation of the installation procedure.
Figure 1. Power button with fingerprint readerFigure 2. Installing the power button with fingerprint reader
Steps
Thread the power-button and fingerprint-reader cable through the opening on the palm-rest assembly.
Place the power button with fingerprint reader on the palm-rest assembly.
Align the screw holes of the power button with fingerprint reader with the screw holes of the power-button bracket.
Replace the four screws (M1.4x2) that secure the power button bracket to the palm-rest assembly.
