- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Drivers and downloads
- System setup
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Locate the Service Tag or Express Service Code of your Dell computer
- System diagnostic lights
- SupportAssist diagnostics
- Built-in self-test (BIST)
- Recovering the operating system
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Backup media and recovery options
- Real Time Clock—RTC reset
- Getting help and contacting Dell
XPS 13 9315 / XPS 9315 Service Manual
Installing the palm-rest and keyboard assembly
Prerequisites
About this task
NOTE The replacement palm-rest and keyboard assembly comes pre-assembled with the following components:
- palm rest
- keyboard
- speakers
- wireless-antenna modules
- touchpad
The following image shows the palm-rest and keyboard assembly.
Steps
Place the palm-rest and keyboard assembly on a flat surface.
Next steps
- Install the
system board.
NOTE The system board can be installed with the attached heat sink.
- Install the I/O daughter-board.
- Install the display assembly.
- Install the fan.
- Install the battery.
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\