- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
XPS 13 9300 Service Manual
Removing the display assembly
Prerequisites
- Follow the procedure in Before working inside your computer.
- Remove the base cover.
About this task
The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
Steps
- Loosen the three captive screws that secure the display-assembly cable bracket to the system board.
- Lift the display-assembly cable bracket off the system board.
- Disconnect the camera cable and the display cable from the system board.
- Remove the three screws (M1.2x2) that secure the display-assembly cable holder to the palm-rest and keyboard assembly.
- Remove the three screws (M2.5x4.5) that secure the left hinge to the system board and the palm-rest and keyboard assembly.
- Remove the three screws (M2.5x4.5) that secure the right hinge to the system board and the palm-rest and keyboard assembly.
- Slide the palm-rest and keyboard assembly from the display assembly.
- After performing all the above steps, you are left with display assembly.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\