- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
XPS 13 9300 Service Manual
Installing the solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
CAUTION Solid-state drives are fragile. Exercise care when handling the solid-state drive.
About this task
The following image indicates the location of the solid-state drive and provides a visual representation of the installation procedure.
Steps
- Align the notch on the solid-state drive with the tab on the solid-state drive slot.
- Gently slide the solid-state drive into the solid-state drive slot.
- Align the solid-state drive shield with the alignment post, and align the screw hole on the solid-state drive shield with the screw hole on the system board.
NOTE The size of the solid-state drive shield is specific to the size of the solid-state drive that is shipped with your computer. The solid-state drive shield cannot be used for a different-sized solid-state drive.
- Replace the screw (M2x3) that secures the solid-state drive shield and the solid-state drive to the system board.
Next steps
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\