- Notes, cautions, and warnings
- Before working inside your computer
- After working inside your computer
- Safety instructions
- Recommended tools
- Screw list
- Removing the base cover
- Replacing the base cover
- Removing the battery
- Replacing the battery
- Removing the solid-state drive
- Replacing the solid-state drive
- Removing the speakers
- Replacing the speakers
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the heat sink
- Replacing the heat sink
- Removing the heat-sink assembly
- Replacing the heat-sink assembly
- Removing the display assembly
- Replacing the display assembly
- Removing the headset port
- Replacing the headset port
- Removing the fans
- Replacing the fans
- Removing the system board
- Replacing the system board
- Removing the power button with optional fingerprint reader
- Replacing the power button with optional fingerprint reader
- Removing the keyboard
- Replacing the keyboard
- Removing the palm-rest assembly
- Replacing the palm-rest assembly
- Device drivers
- System setup
- Troubleshooting
- Getting help and contacting Dell
XPS 13 7390 Service Manual
Procedure
- Align the screw holes on the base cover with
the screw holes on the palm-rest assembly and slide in the base cover
into place.
- Replace the eight screws (M2x3, Torx) that secure
the base cover to the palm-rest assembly.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\