Windows 10 Enterprise 2019 LTSC for Dell Wyse Thin Clients Release Notes

Running the Config Sysprep tool

To run the Config Sysprep tool, do the following:

Go to <drive C>\Windows\Setup.
Right-click Build_Master.cmd, and select Run as administrator.
The Config Master window is displayed.
Figure 1. Config Master
Click Next.
The Configuration screen is displayed.
Figure 2. Configuration
In the Configurations section, select SCCM configuration.
In the Host Name calculation section, enable or disable hostname calculation.
NOTE The Configure Domain Option and Configure local account credentials field are grayed out.
Click Apply to save the changes.
After the completion of SCCM Config Sysprep, the HAgent service ends. You can now perform the pull operation using SCCM.