- Notes, cautions, and warnings
- Revision history
- Introduction
- VxRail components and features
- VxRail Manager overview
- Manage VxRail entitlements
- Manage VxRail passwords
- Administrative tasks
- Replace and add VxRail hardware
- Set up external storage for a dynamic node cluster
- Reboot nodes
- VMware products used with VxRail
Dell VxRail 7.0.x Administration Guide
Monitor the host reboot
Track the status of the reboot for each host.
Steps
- Select the VxRail cluster and click the Configure tab.
- Click Hosts and click Show details.
- On the
Cluster Hosts window, you can verify the success of the reboots:
- If the reboots succeed, the details frame is green. Click Dismiss to close the details window.
- If any reboot fails, the details frame is red. Review the error in the Status column of the details window. To fix the errors, see KB 216816. Complete the required actions and either click RETRY ALL to retry the reboot for the failed nodes, or click CANCEL ALL to cancel this reboot cycle and clear the details window.
If any hosts fail during precheck, set up sequential reboot for others and skip the failed host. The frame around the details window is yellow.Figure 1. Reboots succeed, failed host skipped 
- After all the required actions are completed, click DISMISS to close the details window.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\