Enable external Secure Remote Services
Configure external Secure Remote Services on your VxRail.
Steps
-
From the VMware vSphere Client, click
Hosts and Clusters in the left navigation bar.
-
Select your VxRail cluster and then click the
Configure tab.
-
Select
VxRail >
Support from the inner left navigation bar.
-
Verify the value of
SRS Status.
- Not Configured:
Secure Remote Services is not activated.
- Deployed:
Secure Remote Services has been installed but not activated.
- Enabled:
Secure Remote Services is activated.
-
For each status, perform one of the following:
-
Not Configured, go to step 6.
- Deployed, go to step 12.
- Enabled, go to step 12 or 13.
-
Click
Edit in the
Dell Secure Remote Services section.
-
Select
External SRS.
-
In the
SRS VM IP Address field, enter one or more external Secure Remote Services IP addresses for
VxRail Manager registration (up to 10).
-
Enter the site ID.
-
Select the level of data that is collected for use in the VxRail customer experience improvement program and click
Next.
-
Review your information and click
Finish.
-
Click
Submit.
When your Secure Remote Services status shows as
Enabled, the process is complete.
-
Click
Test Connection to verify the connection.
Data is not available for the Topic