- Notes, cautions, and warnings
- Revision history
- Introduction
- Configurations and features
- Initial setup and configuration
- Pre-operating system management applications
- Manage the pre-operating system applications
- Set up the system
- Configure system BIOS settings
- Configure system Information
- Configure memory settings
- Configure the processor
- Set the NVMe drive mode
- Configure the boot mode
- Configure network settings
- Configure integrated devices
- Serial Communication
- Configure the system profile
- System security overview
- Configure redundant operating system control
- View miscellaneous settings
- iDRAC and device settings
- Configure system BIOS settings
- Dell Lifecycle Controller
- Boot Manager
- PXE boot
- Set up the system
- Manage the pre-operating system applications
- Minimum configuration to POST
- Technical specifications
- Component replacement guidelines
- Jumpers and connectors
- Use system diagnostics
Dell VxRail VD-4520c Hardware Requirements and Specifications
iDRAC and device settings
The
iDRAC settings is an interface to set up and configure the iDRAC parameters by using UEFI. You can enable or disable various iDRAC parameters using the iDRAC settings. Accessing some of the features on the iDRAC settings needs the iDRAC Enterprise License upgrade. For more information about iDRAC, see the
Integrated Dell Remote Access Controller User's Guide .
Device Settings enable you to configure device parameters such as storage controllers or network cards.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\