System ID button is available on the front and back. Press System ID to identify a system in the rack, reset iDRAC, and access BIOS using the step-through mode. When pressed, the System ID LED in the back panel blinks until the front or rear button is pressed again. Press the
System ID to switch between on and off.
If the server stops responding during POST, press and hold
System ID for more than five seconds to enter the BIOS progress mode.
To reset the iDRAC (if not disabled on the iDRAC setup page by pressing F2 during system boot), press and hold the
System ID button for more than 15 seconds.
10
Sled power button
NOTE:When VD-4510c is installed in the VD-4000r or VD-4000z chassis, the power button LED indicator status may be delayed for up to two minutes while the sled is initializing. The power button LED will start slowly blinking to indicate the system is performing the power on sequence after this time period.
11
iDRAC Direct port (Micro-AB USB)
System ID button is available on the front and back. Press System ID to identify a system in the rack, reset iDRAC, and access BIOS using the step-through mode. When pressed, the System ID LED in the back panel blinks until the front or rear button is pressed again. Press the
System ID to switch between on and off.
If the server stops responding during POST, press and hold the
System ID button for more than five seconds to enter the BIOS progress mode.
To reset the iDRAC (if not disabled on the iDRAC setup page by pressing F2 during system boot), press and hold the
System ID button for more than 15 seconds.
12
Slide-out information tag that lists one MAC address and the EST
13
Bezel pogo pin connector is a Spring-loaded, pressure sensitive sensor that indicates when replacement is needed.
The following figure and table describes the components in the rear view of the sled:
The following table describes the components on the rear view of the sled:
Item
Description
1
Upper layer connector cover
2
Upper layer power interposer board (PIB) connector switch
3
Upper layer fans rear view
4
Bottom layer fans rear view
5
Bottom layer PIB connector switch
6
Bottom layer connector cover
The following figure shows the inside view:
The following table describes the components inside the sled:
Item
Component
1
Connector cover
2
Fan handle
3
PIB
4
Riser R1C card
5
2U sled side cover
6
2U sled cooling fan
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\
