Power off the
PowerFlex management controller 2.0 on each of the
PowerFlex management controller VMware ESXi hosts.
Steps
Determine the primary MDM IP address:
Log in to PowerFlex Manager to determine the primary MDM.
To view the details of a resource group, click
Lifecycle > Resource Groups > PowerFlex management controller 2.0 resource group. Scroll to the
Service Details page and make a note of the primary MDM IP address.
Verify the database shutdown. Only the PostgreSQL operator pod
pgo must remain the same when running the command:
#echo $(kubectl get pods -l="postgres-operator.crunchydata.com/control-plane=pgo" --no-headers -o name && kubectl get pods -l="postgres-operator.crunchydata.com/instance" --no-headers -o name) | xargs kubectl get -o wide
Disable vSphere high availability and change startup order of SVMs. If the host is part of a vSphere high availability cluster, the automatic startup and shutdown of VMs is disabled.
Log in to
VMware vSphere Client.
From
vSphere Client > Shortcuts > Hosts and Clusters.
Browse to the cluster.
Click the
Configure tab.
Select
vSphere Availability and click
Edit.
Click the toggle button to disable
vSphere HA.
Click
OK.
Modify the startup order of SVMs to manual to enable the vSphere high availability. This is applicable for all SVMs in the management controller PowerFlex cluster:
In the
VMware vSphere Client, select the host where the VM is located.
Click the
Configure tab.
Under
Virtual Machines, select
VM Startup/Shutdown, and click
Edit.
The
Edit VM Startup and Shutdown window opens.
Select the
Automatically start and stop the virtual machines with the system check box.
Set shutdown action to
Guest shutdown.
To change the startup order of VMs, select a virtual machine from the
Manual Startup category and use the up arrow to move the VM to the
Automatic category.
Select the SVM and move it to
Automatic category. This ensures that the SVM automatically stops and starts with the VMware ESXi system.
Repeat the steps for all the SVMs.
Verify the settings and click
OK.
Gracefully shut down all the VMs except SVMs and vCenter VM:
Log in to
VMware vSphere Client.
From
vSphere Client > Shortcuts > Hosts and Clusters.
Browse and right-click the VM and select
Power > Shut Down Guest OS.
Since SVMs are set to automatically stop and start, there is no need to manually power off.
Identify the host where the vCenter server is running and make a note of the IP address or hostname. If vCenter high availability is enabled, make a note of the IP addresses of the hosts where active, passive, and witness nodes are running:
Log in to
VMware vSphere Client.
From
vSphere Client > Shortcuts > Hosts and Clusters.
Browse the vCenter VM.
Make a note of the host IP address from the
Summary page.
Shut down the vCenter server VM gracefully. If you have vCenter high availability that is configured, shut down the active, passive, and witness nodes:
Log in to the VMware ESXi using the host client.
Click
Virtual Machines > Select the vCenter VM and click to open a browser console.
Press
F12 to shut down the VM.
Enter the root password and press
OK.
Shut down the VMware ESXi servers gracefully:
Log in to VMware ESXi Host Client.
Right-click
Host and select
Shut down.
To confirm the shutdown of the selected host, click
SHUT DOWN.
Repeat the steps for all the remaining nodes.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\