Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerFlex Appliance with PowerFlex 4.x Administration Guide

PDF

Managing components with PowerFlex Manager

Once PowerFlex Manager is configured, you can use it to perform the ongoing tasks necessary to manage your PowerFlex appliance.

The following table describes typical tasks for managing PowerFlex appliance components and what steps to take in PowerFlex Manager to initiate each:

Table 1. Managing components using PowerFlex ManagerTypical tasks for managing components and what steps to take in PowerFlex Manager.
If you want to... Do this in PowerFlex Manager...
View network topology
  1. Click Lifecycle > Resource Groups.
  2. On the Resource Groups page, select a resource group.
  3. On the Resource Group Details page, click the Port View tab.
Run inventory (PowerFlex nodes, switches, and VMware vCenter cluster).
  1. Click Resources and click the All Resources tab.
  2. Click the check box for the resource you want to update and click Run Inventory.
  3. After running the inventory, click Resource Group Details under More Actions on the Resource Groups page for any resource group that requires the updated resource data.
Add an existing resource group
  1. Click Lifecycle > Resource Groups.
  2. Click +Add Existing Resource Group.
Perform PowerFlex node expansion
  1. Click Lifecycle > Resource Groups.
  2. On the Resource Groups page, select a resource group.
  3. On the Resource Group Details page, under Add Resources and click Add Nodes.
The procedure is the same for new resource groups and existing resource groups.
Remove a PowerFlex node
  1. Click Lifecycle > Resource Groups.
  2. On the Resource Group page, select a resource group.
  3. On the Resource Group Details page, under More Actions, click Remove Resource.
  4. Select Delete Resource for the Resource removal type.
Enter service mode
  1. Click Lifecycle > Resource Groups.
  2. On the Resource Group page, select a resource group.
  3. On the Resource Group Details page, under More Actions, click Enter Service Mode.
Exit service mode
  1. Click Lifecycle > Resource Groups.
  2. On the Resource Group page, select a resource group.
  3. On the Resource Group Details page, under More Actions, click Exit Service Mode.
Reconfigure MDM roles
  1. Click Lifecycle > Resource Groups.
  2. On the Resource Group page, select a resource group.
  3. On the Resource Group Details tab, click Reconfigure MDM Roles under More Actions.
You can also reconfigure MDM roles from the Resources page. Select a PowerFlex gateway and click View Details. Click Reconfigure MDM Roles.
Replace a drive
  1. Click Lifecycle > Resource Groups.
  2. On the Resource Group page, select a resource group.
  3. On the Resource Group Details page, underPhysical Nodes > Component Replacement , click Drive Replacement.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\