Dell PowerFlex Appliance with PowerFlex 4.x Administration Guide

Ingress and events propagation to syslog

Use this procedure to ingress and events propagation to syslog.

1. Go to /opt/platform-provisioner/support_scripts and run the ./install_audit.sh script once from any of the MVM nodes. Provide the PowerFlex user credentials at the credential prompt.

   # Enter the node
   cd /opt/platform-provisioner/support_scripts; ./install_audit.sh
   # Installing observability, If there is issue break and repeat
   # PFXUSER must be defined to the powerflex admin user, something like:
   # PFXUSER="admin" PFXPASSWORD="Scaleio123!" ./install_audit.sh
   # Enter your PFX USER : Enter PFX PASSWORD :

   This may take 20 minutes, do not close this terminal until this script completes successfully.
2. User credentials must be supplied in the environment or as a variable in the command line above. If the variable is missing, it prompts for it to be entered.
3. If the process failed or was interrupted, there might be a job running in the platform manager:

   "{"title": "An execution is already in progress", "description": "Please refer bedrock log for more details"}++ wait_for_done"
   ...
   No ID - check error

   The process can be run again when this job completes.
   The script checks for having 10 observability services as a check that it successfully completed the install observability part. Then it completes the platform installer configuration change.