Dell PowerFlex Appliance with PowerFlex 4.x Administration Guide

Add the storage-only resource group back to PowerFlex Manager

Use this procedure to the storage-only resource group back to PowerFlex Manager.

1. Log in to PowerFlex Manager.
2. Click Lifecycle > Resource Groups.
3. Click Add Existing Resource Group and click Next.
4. Enter the resource group name that was removed in the Name field.
5. For the Type of resource group, select Storage Only.
6. Under Firmware and Software Compliance, select the version recorded earlier.
7. Click Next.
8. Choose Full Network Automation
9. On the Cluster Information page, enter a name for the cluster component in the Component Name field.
10. Select volumes for the cluster settings:
    1. Target PowerFlex Gateway - Select the gateway where the cluster is available
    2. Protection Domain - Select the name of the gateway where the cluster is available
    3. OS Image - Select the image or choose Use Compliance File Linux image if you want to use the image provided with the target compliance version. PowerFlex Manager filters the operating system image choices to show only Linux images for a storage-only service.
11. Select the credentials and click Next.
12. Review the inventory on the Inventory Summary screen.
13. Click Next.
14. On the Network Mapping page, review the networks that are mapped to port groups and make any required edits.
15. Click Next.
16. Review the Summary page and click Finish.
    Repeat for each site until all systems in the replication topology have been converted.