Dell PowerFlex Appliance with PowerFlex 4.x Administration Guide

Install and configure PuTTY

Use this procedure to install and configure PuTTY.

1. To download PuTTY:
   1. Using a web browser of the machine you intend to connect to the jump server with, go to PuTTY and click Download PuTTY. If troubleshooting is required after following the steps provided, it is recommended to read the documentation that is provided with the software.
   2. From Alternative binary files, download the putty.exe for 32-bit x86 to skip installation. If you cannot run or download the binary files, contact your system administrator for assistance.
2. Double-click putty.exe to run the binary file.
   The PuTTY Configuration window opens.
3. Enter the following values:

   Table 1. PuTTY fields to configureEnter the following values for the PuTTY fields to configure.

   Field	Do the following
   From the Basic options for your PuTTY session	Enter the username and IP address in the Host Name field. For example, admin@10.0.0.5.
   Port	Enter 22.
   Connection Type	Select SSH.
   Saved Session	Enter PowerFlex Jump Server and click Save.

4. Click Open.
   When a warning appears, verify that you are connecting to the appropriate host and click Accept.
   If you are using the same jump server, the warning does not appear again. If the time taken to accept the connection is too long, a session time out occurs. If you see an empty console, close the session and reconnect.