Dell PowerFlex Appliance with PowerFlex 4.x Administration Guide

Configure SupportAssist using the connect directly mode

Use this procedure to enable SupportAssist using the connect directly mode.

1. Log in to PowerFlex Manager.
2. Click Settings > Events and alerts.
3. Click Notification Policies.
4. On the Destinations pane, click SupportAssist.
5. Accept the license and telemetry agreement on the connect support assist page and click Next.
6. Choose the connection type Connect Directly.
   NOTE:This helps us directly connect to SupportAssist direct. Call to home feature works on connect direct. The proxy setting is not supported.
7. Click Connect to cloudIQ.
   It enables PowerFlex Manager to transport telemetry data, alerts and analytics to assist Dell Technologies in providing support.
8. On the Authentication details page, provide the following details.
9. Access key and PIN, see Generate Access Key and PIN for Secure Connect Gateway 5.x.
   You need the software ID for generating the access key and PIN.
10. Choose the Device type to be registered like rack, appliance or software.
11. In the Enterprise License Management Systems file, enter the software ID used in step 2 while generating the access key and pin.
12. The Solution serial number must be provided by customer.
13. In the Site ID field, provide the site ID location. If you do not have one, contact Dell Technologies Support to generate one.
14. Click Next, provide the contact details for customer, and click Finish.
    A window appears on the bottom of the screen configuring SupportAssist and another window appears once it is successfully configured.
15. To activate the policy, click Configure Now and enable the policy by making it active.
    Once the policy is active, the policy will move from grayed out mode to available and active mode.