Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Vostro 3710 Service Manual

PDF

Installing the system board

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

NOTE:The Service Tag information of your computer is stored in the system board. You must enter the Service Tag in the BIOS setup program after you replace the system board.
NOTE:Replacing the system board removes any changes that you have made to the BIOS using the BIOS setup program. You must make the appropriate changes again after you replace the system board.
NOTE:Before disconnecting the cables from the system board, note the location of the connectors so that you can reconnect the cables correctly after you replace the system board.

The following image(s) indicate the location of the system board and provides a visual representation of the installation procedure.

Installing the system board

Installing the system board

Installing the system board

Steps

  1. Slide the system board at an angle with the rear external ports aligned to their respective openings of back panel at the rear of the chassis.
  2. Place the system board onto the chassis and ensure the front I/O-ports are placed into the front I/O-slots on the chassis.
  3. Replace the seven screws (#6-32) and the screw (#6-32x3.8) that secure the system board to the chassis.
  4. Route and connect the following cables to the system board. See the system-board components for more information about the respective connectors of the following cables:
    • hard-drive and optical-drive power cable
    • optical-drive data cable
    • hard-drive data cable
    • system-board power cable
    • power-button cable
    • processor-power cable
  5. Place and align the front I/O-bracket with I/O slot on the chassis.
  6. Replace the screw (#6-32) that secures the front I/O-bracket to the chassis.

Next steps

  1. Install the processor.
  2. Install the fan and heat-sink assembly.
  3. Install the fan shroud.
  4. Install the media-card reader.
  5. Install the coin-cell battery.
  6. Install the wireless card.
  7. Install the M.2 2230 solid-state drive or M.2 2280 solid-state drive, which is applicable.
  8. Install the memory.
  9. Install the HDD and ODD cage.
  10. Install the 3.5-inch hard drive.
  11. Install the front cover.
  12. Install the left-side cover.
  13. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\