- Notes, cautions, and warnings
- Working on your computer
- Chassis view
- Removing and installing components
- Recommended tools
- Removing the battery
- Installing the battery
- Removing the optical drive
- Removing the optical drive bracket
- Installing the optical drive bracket
- Installing the optical drive
- Removing the keyboard
- Installing the keyboard
- Removing the base cover
- Installing the base cover
- Removing the hard drive assembly
- Removing the hard drive from the hard drive bracket
- Installing the hard drive into the hard drive bracket
- Installing the hard drive assembly
- Removing the memory module
- Installing the memory module
- Removing the coin cell battery
- Installing the coin cell battery
- Removing the WLAN card
- Installing the WLAN card
- Removing the Input Output board
- Installing the Input Output board
- Removing the speakers
- Installing the speakers
- Removing the heat sink assembly
- Installing the heat sink assembly
- Removing the system board
- Installing the system board
- Removing the power connector
- Installing the power connector
- Removing the display assembly
- Installing the display assembly
- Removing the display bezel
- Installing the display bezel
- Removing the camera
- Installing the camera
- Removing the display panel
- Installing the display panel
- Removing the palmrest
- Installing the palmrest
- Removing the display hinges
- Installing the display hinges
- Technology and components
- System Setup
- Enhanced Pre-Boot System Assessment — ePSA diagnostics
- Technical specifications
- System specifications
- Processor specifications
- Memory specifications
- Audio specifications
- Video specifications
- Camera specifications
- Communication specifications
- Port and connector specifications
- Display specifications
- Keyboard specifications
- Touchpad specifications
- Battery specifications
- AC Adapter specifications
- Physical specifications
- Environmental specifications
- Contacting Dell
Dell Vostro15–3565 Owner's Manual
Installing the Input Output board
- Connect the input/output (I/O board) cable to the I/O board.
- Replace the black adhesive tape to secure the i/o board cable.
- Turn the I/O board over and align it with the screw holder on the computer.
- Insert the I/O board into the computer.
- Tighten the screw to secure the I/O board to the computer.
- Install the:
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\