- Notes, cautions, and warnings
- Working on your
computer
- Before working inside your computer
- Turning off your computer
- After working inside your computer
- Removing the cover
- Installing the cover
- Removing the front bezel
- Installing the front bezel
- Removing the hard drive assembly
- Installing the hard drive assembly
- Removing the optical drive
- Installing the optical drive
- Removing the heat sink fan cover
- Installing the heat sink fan cover
- Removing the heat sink assembly
- Installing the heat sink assembly
- Removing the memory
- Installing the memory
- Removing the power supply unit
- Installing the power supply unit (PSU)
- Removing the system fan
- Installing the system fan
- Removing the WLAN card
- Installing the WLAN card
- Removing the coin cell battery
- Installing the coin cell battery
- Removing the expansion card
- Installing the expansion card
- Removing the system board
- Installing the system board
- System Board Layout
- Troubleshooting your computer
- System Setup overview
- Specifications
- Contacting Dell
Dell Vostro 3250 Owner's Manual
Installing the system board
- Insert the system board and ensure that ports are aligned to the holes on the back panel.
- Push the I/O panel to its original position until it snaps in.
- Tighten the screw to secure the I/O panel to the chassis.
- Connect the cables to the system board.
- Install:
- Follow the procedures in After Working Inside Your Computer .
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\