Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

Vostro 7500 Service Manual

Removing the DC-in port

Prerequisites

  1. Follow the procedure in before working inside your computer.
  2. Remove the base cover.
  3. Remove the battery.

About this task

The figure indicates the location of the DC-in port and provides a visual representation of the removal procedure.

Removing DC-in port

Steps

  1. Remove the two screws (M2.5x5) and (M2.5x4) that secure the left display hinge to the palm-rest and keyboard assembly.
  2. Open the left display hinge at an angle of 90 degrees.
  3. Disconnect the DC-in port cable from the system board.
  4. Remove the single screw (M2x3) that secures the DC-in port to the palm-rest and keyboard assembly.
  5. Lift the DC-in port, along with its cable, off the palm-rest and keyboard assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\