- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw List
- Major components of Vostro 15 3510
- Secure Digital Card
- Base cover
- Battery
- Memory modules
- WLAN card
- Solid-state drive
- Hard drive
- System fan
- Heat sink
- Speakers
- IO board
- Touchpad
- Display assembly
- Hinge caps
- Display bezel
- Hinges
- Display panel
- Camera
- Display eDP cable
- Display back-cover
- Power button
- Power button with fingerprint reader
- System board
- Power-adapter port
- Palm-rest and keyboard assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System diagnostic lights
- Recovering the operating system
- Real Time Clock—RTC reset
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Vostro 15 3510 Service Manual
Removing the I/O board
Prerequisites
- Follow the procedure in before working inside your computer.
- Remove the SD card.
- Enter service mode.
- Remove the base cover.
About this task
The following images indicate the location of the I/O board and provides a visual representation of the removal procedure.
Steps
- Open the latch and disconnect the fingerprint-reader board cable from the I/O board, if applicable.
- Open the latch and disconnect the I/O-board power cable from the I/O board.
- Remove the two (M2x3) screws that secure the I/O board to the palm-rest and keyboard assembly, and remove the I/O board from the system.
- Remove the three (M2x3) screws that secure the I/O board to the palm-rest and keyboard assembly, and remove the I/O board from the system.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\