Vostro 14 3430 Owner's Manual

Installing the display panel

CAUTION: The information in this section is intended for authorized service technicians only.

If you are replacing a component, remove the existing component before performing the installation procedure.

NOTE: This procedure applies only to computers with a plastic chassis.

The following images indicate the location of the display panel and provide a visual representation of the installation procedure.

Image of connecting the display panel cable

Image of installing the display panel

Place the display panel and display assembly on a clean and flat surface.
Connect the display cable to the connector on the display panel and close the latch.
Adhere the tape to secure the display cable to the connector on the display panel.
Turn the display panel over and place the display panel on the display back-cover.
Lift the bottom side of the display panel and slide the top side into the slots at the top of the display back-cover.
Gently push down on the edges of the display panel until it clicks into the tabs on the display back-cover.
Replace the two screws (M2x2) to secure the display panel to the display back-cover and antenna assembly.