Vostro 3405 Service Manual

Installing the M.2 2230 solid-state drive

If you are replacing a component, remove the existing component before performing the installation process.

NOTE This procedure applies if you are installing a M.2 2230 solid-state drive.

NOTE The M.2 card installed on your computer will depend on the configuration ordered. Supported card configurations on the M.2 card slot:

The following images indicate the location of the M.2 2230 solid-state drive and provides a visual representation of the installation procedure.

Installing the M.2 2230 solid-state drive

Place the solid-state drive into the thermal plate and install the single (M2x2) screw.
Align the notch on the M.2 2230 solid-state drive with the tab on the M.2 card slot on the system board.
Slide the M.2 2230 solid-state drive into the M.2 card slot on the system board.
Replace the single (M2x2.2) screw and tighten the single captive screw to secures the thermal plate to the palmrest.