- Notes, cautions, and warnings
- Working on your computer
- Technology and components
- Exploded View
- Disassembly and reassembly
- Secure Digital Card
- Base cover
- Battery
- Memory modules
- WLAN card
- Solid-state drive
- Hard drive
- Coin-cell battery
- System fan
- Heat sink
- Speakers
- IO board
- Touchpad
- Display assembly
- Display bezel
- Camera
- Display panel
- Display back-cover and antenna assembly
- Power button
- System board
- Power-adapter port
- Palm-rest and keyboard assembly
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Enhanced Pre-Boot System Assessment (ePSA) diagnostics
- System diagnostic lights
- Real-Time Clock (RTC Reset)
- Updating the BIOS in Windows
- Updating the BIOS using the USB drive in Windows
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Vostro 3401 Service Manual
Removing the display bezel
Prerequisites
- Follow the procedure in before working inside your computer.
- Remove the SD card.
- Remove the base cover.
- Remove the battery cable.
- Remove the display assembly.
About this task
Steps
- Using a plastic scribe, pry the display bezel from the outer edge to separate it from the display assembly.
- Lift the display bezel from the display assembly.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\