- Notes, cautions, and warnings
- Working on your computer
- Removing and installing components
- Recommended tools
- Screw list
- Base cover
- Battery
- Coin-cell battery
- Solid-state drive
- Heat sink
- Fan
- Speakers
- WLAN card
- WWAN card
- Touchpad
- Display assembly
- Power-adapter port
- I/O board
- Power-button board
- Power button with fingerprint reader
- System board
- Display bezel
- Display panel
- Display hinges
- Camera
- Display cable
- Display back-cover
- Palm-rest and keyboard assembly
- System setup
- Troubleshooting
- Getting help
Dell Vostro 5391 Service Manual
Installing the display back-cover
If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the display back-cover and provides a visual representation of the installation procedure.
Place the display back-cover on a flat surface.
- Install the camera.
- Install the display cable.
- Install the display panel.
- Install the display hinges.
- Install the display bezel.
- Install the display assembly.
- Install the WLAN card.
- Install the battery.
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\