- Notes, cautions, and warnings
- Preface
- Introduction
- Access Control
- Access control settings
- Security for management access
- Authentication
- Authorization
- Component access controls
- Data security settings
- Password policy
- Physical security controls
- Login banner and message of the day
- Logging
- Communication Security
- Communication security settings
- Port usage
- Ports used by Unisphere components on VNX for block
- How VNX for file works on the network
- Network encryption
- Management support for TLS communications on VNX2 systems
- SSL certificates
- Planning considerations for Public Key Infrastructure on VNX for file
- IP packet reflect on VNX for file systems
- Effect of filtering management network
- vSphere Storage API for Storage Awareness (VASA) support
- Special configurations
- Secure Remote Procedure Call
- Other security considerations
- Data Security Settings
- Data at Rest Encryption overview
- Data at Rest Encryption feature activation
- Encryption status
- Backup keystore file
- Data in place upgrade
- Hot spare operations
- Adding a disk drive to a VNX with encryption activated
- Removing a disk drive from a VNX with encryption enabled
- Replacing a chassis and SPs from a VNX with encryption enabled
- Security Maintenance
- Advanced Management Capabilities
- Secure deployment and usage settings
- TLS cipher suites
- LDAP-based directory server configuration
- VNX for file CLI role-based access
- VNX for file CLI security configuration operations
- Configuring password policy
- Configuring session timeout
- Protect session tokens
- Configuring network encryption and authentication using the SSL protocol
- Configuring PKI
- Creating the certificate provided by the persona
- Using the Control Station as the CA
- Obtaining CA certificates
- Generate a key set and certificate request
- Send the certificate request to the CA
- Import a CA-signed certificate
- List the available CA certificates
- Acquire a CA certificate
- Import a CA certificate
- Generate a new Control Station CA certificate
- Display the certificate
- Distribute the Control Station CA certificate
- Request and Install Customer-Supplied Certificates for Control Station
- Managing PKI
- Customize a login banner
- Create a MOTD
- Restrict anonymous root login
- Locking accounts after a specific number of failed logins
- VNX for block SSL certificate import
EMC® VNX® Series Security Configuration Guide for VNX
Change the session timeout value
About this task
The default session timeout value for Control Station shell sessions is 60 minutes. Inactivity or idle time is defined as the time since a primary shell prompt was displayed and no input has been received. Therefore waiting at a prompt within a command for some indeterminate amount of time is not affected by the session timeout value.
Steps
To change the session timeout value, use this command syntax:
# /nas/sbin/nas_config -sessiontimeout<minutes>
where:
<minutes> = number of minutes for session timeout (in the range 5 through 240)
Example:
To change the session timeout value to 200 minutes, type:
# /nas/sbin/nas_config -sessiontimeout 200
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\