- Notes, cautions, and warnings
- Introduction
- Installing vSphere VMware ESXi 8.0
- Download the Dell customized ESXi image files
- To install, enable or to disable ESXi
- Enabling Dell Fault Resilient Memory
- Enable Dell NUMA Fault Resilient Memory
- Dell NVDIMM-N persistent memory
- Intel Optane Data Center Persistent Memory Module
- 4K Native hard drive support with ESXi hosts
- Trusted Platform Module
- Quick Boot
- HTTP or HTTPS boot
- vSphere Life Cycle Manager
- Dell add-on package
- Surprise removal of NVMe device
- Data Processing Unit
- Installing ESXi on flash media
- Installing ESXi on the hard drive
- Installing ESXi on the BOSS-S1 or BOSS-N1 device
- Enabling or disabling flash storage device
- Configuring one-time boot to ESXi
- Configuring boot sequence to ESXi
- VMware ESXi Secure boot support for Dell PowerEdge Servers
- Downloading patches and updates for ESXi
- Creating vCenter Server installation media
- Installing vCenter Server
- Deploying VMware vSphere ESXi 8.x
- Back up and restore configuration
- Troubleshooting ESXi
- Getting help
VMware vSphere ESXi 8.x on Dell PowerEdge Systems Installation Instructions and Important Information Guide
HTTP or HTTPS boot
VMware ESXi 8.0 can be deployed through HTTP or HTTPS. This method is referred to as HTTP or HTTPS boot. Use the method to deploy the operating system and replace the existing legacy PXE-based boot method with the TFTP protocol. This method uses DHCP, DNS, and HTTP or HTTPS to securely deploy an operating system over a network.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\