Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

VMware vSphere ESXi 8.x on Dell PowerEdge Systems Installation Instructions and Important Information Guide

PDF

Configuring boot sequence to ESXi

About this task

To boot your system to ESXi, complete the following steps:
NOTE:After the internal flash device port is enabled, your system continues to boot to ESXi.

Steps

  1. Turn on your system.
    The Dell logo is displayed.
  2. Press F2 to open the System Setup page.
    After you complete the system boot, the System BIOS configuration menu is displayed.
  3. Select Hard-Disk Boot Sequence by using the up- and down-arrow keys, and then select the relevant boot device.
  4. Press the hyphen key (-) to move up the relevant boot device in the order.
    CAUTION: It is recommended that you do not modify other settings unless you are familiar with the settings. Modifying settings could cause your system to fail to boot or function properly.
  5. Press Enter, and then follow the on-screen procedure to save these changes.
  6. Restart your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\